News

Home / News

How to debug the servo motor correctly
13-01-2021
1 initialization parameters Before wiring, initialize the parameters. On the control card: select the control method; clear the PID parameters; let the default enable signal turn off when the control card is powered on; ...
Five ways to prevent the motor from burning
06-01-2021
At work, everyone must have encountered many motor burns. Some were due to mechanical problems, some were due to thermal relay problems, and some were burned due to lack of phase. As the saying goes, if a worker wants to...
What should be paid attention to when selecting geared motors
29-12-2020
Choose a reduction ratio close to the ideal: Reduction ratio=Servo motor speed / reducer output shaft speed; torque calculation: for the life of the special-shaped reducer, torque calculation is very important, and pay a...
The difference and connection between DC motor and AC motor
24-12-2020
Both DC motors and AC motors have a wide range of applications. The basic principles of their work are the same, and both are the law of electromagnetic induction. Both have their own advantages and disadvantages. To ana...
Debug steps for motion controller to control servo motor
16-12-2020
The motion controller is to control the operation of the motor: for example, the motor is driven by the stroke switch to control the AC contactor to realize the motor drags the object to run up to the specified position ...
Why does the motor burn
10-12-2020
Why does the motor burn out? As one of the most commonly used moving equipment, what is the cause of the burning phenomenon? Starting with load can cause damage to the motor; The actual use head is too much lower than th...